A camera for the ZedBoard with the MT9D111 sensor.
JA/JB Front View
-------------------------------
| 6 | 5 | 4 | 3 | 2 | 1 |
-------------------------------
| 12 | 11 | 10 | 9 | 8 | 7 |
-------------------------------
The table below is the pin reference used in this project. It can be changed in the file zedcam_constraints.xdc.
| Pin Name | ArduCam Pin | Zynq Pin | ZedBoard Pin |
|---|---|---|---|
| 3.3 V | VCC | - | JA6/JA12/JB6/JB12 |
| Ground | GND | - | JA5/JA11/JB5/JB11 |
| I2C Serial Data | SDA | AB9 | JA9 |
| I2C Serial Clock | SCL | AA8 | JA10 |
| HSYNC | HS | AB10 | JA8 |
| VSYNC | VS | AA9 | JA4 |
| Xtal Clock | XCLK | Y10 | JA3 |
| Pixel Clock | PCLK | AB11 | JA7 |
| Data 7 | D7 | V8 | JB10 |
| Data 6 | D6 | V9 | JB9 |
| Data 5 | D5 | W10 | JB8 |
| Data 4 | D4 | V12 | JB7 |
| Data 3 | D3 | W8 | JB4 |
| Data 2 | D2 | V10 | JB3 |
| Data 1 | D1 | W11 | JB2 |
| Data 0 | D0 | W12 | JB1 |
| Standby | STB | Y11 | JA1 |
| Reset | RST | AA11 | JA2 |
NOTE 1: Xtal Clock (XCLK) = 10 MHz
NOTE 2: I2C pins with pull-up enabled.
- I2C device:
/dev/i2c-0 - Image address:
0x43C00000 - Reset pin address:
0x41200000 - Standby pin address:
0x41210000